Assistance Needed: Testing MCS and Output Power on ESP32 + MM HaLow Dev Kit

General
1

We evaluated RF Wi-Fi HaLow using a development kit comprising an ESP32 board and a Morse Micro HaLow module. RF parameters are configured via morse_cli, and the test firmware is sourced from Morse Micro’s official GitHub repository.

However, the current setup does not support configuring or testing different Modulation and Coding Schemes (MCS), which are essential for evaluating output power across various data rates. Specifically, morse_cli lacks support for MCS configuration, signal generator control, and initiating signal transmission on the HaLow module via the ESP32.

Could you advise or provide guidance on how to enable these capabilities?

Thank you in advance.

2

Hello,

These tools aren’t released publicly, but they are free to acquire - as obviously device manufacturers require them.
Please make sure you have an account for our Customer Portal and then email support@morsemicro.com requesting access to the tools with a brief explanation of why you need them :slight_smile: