I did range test with HaLowLink-1 and it seems pretty good. I was wondering if the VFEM in HaLowLink-1 is using 3V3 or 4V3. I am asking as while doing power measurements for HaLow using EKH-05 V3, I found that VFEM has two power options.
There is an option to enable 4.3V VFEM for the HaLow module. It’s pretty deep in the menus, though. Enable Advanced Config, then under Network → Wireless click Edit next to your HaLow network. Under Device Configuration, there is an Advanced Settings tab. Check the box next to 4.3V VFEM.
1 Like