Halow Link2 (AU) with Third-Party TXW8301 STA Module

Software
1

Dear Support Team,

I recently purchased your product, and I am currently attempting to establish a connection between the Halow Link2 (AU) (configured as an Access Point) and a third-party TXW8301-based module (configured as a Station/Client). Unfortunately, I have been unsuccessful in getting the two devices to associate with each other despite multiple attempts.

I would like to ask:

  1. Are there any specific configuration steps, AT commands, or firmware settings required on the Halow Link2 (AU) to ensure compatibility with non-proprietary TXW8301 STA modules?

  2. If direct interoperability is not officially supported, could you recommend an alternative approach or a workaround to achieve a stable link between these devices?

  3. Is there any documentation, reference design, or community-tested method that you can share to facilitate this type of cross-vendor HaLow connection?

Any guidance, recommended settings, or debug steps you can provide would be greatly appreciated.

Thank you for your support.

Best regards,

2

This is discussed in HaLowLink2 compatibility with TXW8301 and we need more information from Taixin about their WPA3 support.

Their AT command set appears to use legacy authentication protocols which we do not support, as they are not “Wi-Fi HaLow”.

Closing this thread. Please update the other thread with information about Taixin’s WPA3 support if/when they get back to you.