I am currently working on a project that has two (with the possibility of more) nodes communicating in a mesh using MM8108s. I would like to try to add the capability of some sort of pseudo frequency hopping, with the end goal being a hop every second with less than 10% data loss. I looked into ways of dynamically changing the frequency of the MM8108 and found the morse_cli commands. Do the drivers or the firmware allow for frequency hopping?
Strategies I have tried and the results I have found:
So far I have kept my testing to very slow hopping between two frequencies with the same bandwidth and primary bandwidth. I created a bash script that uses real time from GNSS to change at a rate of one hop every three seconds and had 90% loss in data. This was after I had isolated one of the cores on my raspberry pi cm4 to only run this script.
You might want to look at the various “channel switch announcement” configuration that is available. Unfortunately this hasn’t been implemented/tested or scoped for 802.11s mesh networks on our side, but interested to see where you can get with it.
Actually I want to do the same, since now there is big limitation to the mesh configuration. It’s hard to foresee which channel has less noise before deployment. And maybe the noise is only in specific time period. To be able dynamically switch channel is a strong need from enterprise deployment. Since I have my own MAC layer, and custom protocol and cloud management platform. I can see the mesh health in real time and also be able switch using a MQTT protocol.